Step-by-Step Instructions

Following the steps below will get your Revv 1 display back to the original factory settings.

NOTE: Depending on the generation of your Revv 1 display, the P10 settings may not be available. If the P10 mode is not present, a factory reset will not be possible on your display.

Step 1:

Turn on your Revv 1 bike and ensure the display is on the main screen. Press and hold the "M" button to access the settings screen.

Step 2:

On the settings screen, press the "M" button to get into the 0000 screen, then enter code 1919. Your display will enter Advanced settings. Number selection: use the + and - buttons to change the digits. Use the Power button to move and select the digits.

Step 3:

Tap the "M" button to navigate to the P10 setting; this should default to "NO" on the screen.

Step 4:

Reset to factory defaults: press the + button, navigate to YES, then press and hold the "M" button to reset.

Please reach out to our support team with any additional questions. Happy Riding!