Materials Needed

  • Ride1Up Hex Keys
  • Pre-Built Revv Storage Cage
  • Flat Screws

Step 1: Remove Storage Cage from the Box

  1. Remove the storage case and lay it on a flat surface.
  2. Remove the four preinstalled M5x10mm hex screws on top of the controller box.
  3. Save the existing hardware for installation or use the provided hardware.

Step 2: Secure Storage Cage

  1. Align the storage case and ensure pre-drilled holes are lined up with the controller box.
  2. Using the supplied flat screws, thread into the controller box and tighten until flush with the storage case.

Step 3: Setting a Unique Code for the Center Storage Cage Combination Lock

  1. Note: Pre-set code is 000.
  2. Push the small silver code setting pin on the side of the circular dial in with a small instrument or screwdriver.
  3. Set your desired code.
  4. Remove the screwdriver, allowing the setting pin to return to place.

Final Steps & Important Notes

  • Ensure the cage is secure and tight by gently moving it.
  • Periodically check the flat screws to ensure they are secure to the controller box.

For any questions or additional assistance, please contact customer support.